JahooPak Woven Strapping Details
Buyers usually start with one number, the system strength, and then have to decide how many straps to use. The figure printed against each model is the strength of the complete assembly, tape plus the closing method it is supplied with, which is why the heavy series is quoted as a system value and always ships with a defined buckle. Read the table in three columns, left to right: model, width, then system strength, and treat the coil length and pallet count as the packing consequence of those three.
The heavy series runs from SL105 at 32 mm and 4,000 kg through SL150 at 38 mm and 6,000 kg and SL200 at 40 mm and 8,500 kg, up to SL750 at 50 mm and 12,000 kg. The steps are not decorative. A 12 tonne steel coil is normally held by more than one strap, so the practical question is how many passes at what angle. Straight passes across the load use the full rating; a pass that runs at an angle or over a corner protector loses part of it, and a knotted end loses more. Work from the cargo weight, divide by the number of planned passes, add the margin your own rules require, and the model follows. SL750 with 100 m per coil suits a few long passes; SL105 with 250 m per coil and 36 cartons per pallet suits many shorter passes on mixed loads, which is why it packs denser than the other three models at 20 cartons per pallet.
The light series is chosen differently, because at 600 kg to 2,160 kg the operator often ties by hand and the tape width matters as much as the load. TW40 at 13 mm and 600 kg up to TW55 at 16 mm and 960 kg covers parcels, bundles and light pallets. Above that the width alone no longer tells the story: TW60 is 19 mm and rates 928 kg while TW55 is 16 mm and rates 960 kg, because yarn count and weave density differ between models. TW75 at 19 mm and 1,780 kg, TW85 at 25 mm and 1,600 kg, TW80-1200 at 25 mm and 1,920 kg and TW86-1350 at 25 mm and 2,160 kg sit close together by design, so a buyer can keep the same 25 mm hardware and still step up the strength. All light models pack 3 rolls per carton, which keeps the carton count predictable when a mixed order is loaded.
Buckle matching is the part that is easiest to get wrong. Heavy models take JHD B10 for SL105, JHD B12 for SL150 and SL200, and JHD B15 for SL750; the JAHOOPAK phosphated coated wire buckle JB N10 can be supplied with any heavy model as an alternative. Never substitute a plain buckle to save cost, and never put a phosphated buckle on a composite strap. If a shipment mixes heavy and light models, ask for the buckle list per model before the order is confirmed, so the packing list and the hardware arrive in the same proportion.